Next: Simulator control and debugging
Up: Command line options
Previous: Other architectural configuration parameters
In this section, we distinguish between ``simulation'' input and output
and ``standard'' input and output. Standard input and output refer to the
standard input and output streams provided to the application being
simulated. By default, these are the same as the input and output
streams used by the simulator. However, the simulator input and output
streams can be redirected separately from the application input and
output, as described below.
- -0 file
- Redirects standard input to file. Defaults to stdin.
- -1 file
- Redirects standard output to file. Defaults to stdout.
- -2 file
- Redirects standard error to file. The simulator outputs its concise statistics to this file. Defaults to stderr.
- -3 file
- Redirects simulator detailed statistics to file. This
option can be used (either alone or in conjunction with ``-1'') to
redirect detailed statistics separately from the output produced by
the application. (If ``-1'' is used without ``-3'', both detailed
statistics and application output are written to the same file.)
Defaults to stdout.
- -D dir
- Directory for output files. This option can only be used
in conjunction with the ``-S'' option. Unused by default.
- -S subj
- Subject to use in output filenames. This option
overrides ``-1'', ``-2'', and ``-3'', and can only be used in
conjunction with ``-D.'' When this option is used, RSIM redirects
application standard output to a file titled dir/subj_out,
redirects application standard error and simulator concise statistics to
dir/subj_err, and redirects simulator detailed statistics to
dir/subj_stat. Unused by default.
- -z file
- Redirects simulator input (configuration file) to
file. This option can be
used (either alone or in conjunction with ``-0'') to redirect the
input required by the simulator (such as the configuration file)
separately from the input required by the application. (If ``-0'' is
used without ``-z'', both the simulator input and application input come
from the same file.) Note: to use the default values of all configuration
file parameters,
file should be set to /dev/null. Defaults to stdin.
- -e emailaddr
- Send an email notification to the specified
address upon completion of this simulation. The notification tells the
user the location of the various output files and is sent using the
subject specified in ``-S''. Unused by default.
Next: Simulator control and debugging
Up: Command line options
Previous: Other architectural configuration parameters
Vijay Sadananda Pai
Thu Aug 7 14:18:56 CDT 1997