Next: Configuration file
Up: Command line options
Previous: Parameters related to simulation
- -f file
- Name of application file to interpret with RSIM, without the .out or .dec
suffix. Defaults to ``a''.
- -A num
- Every num minutes, the simulator will print out
partial statistics,
which simply provide the number of cycles since each processor last
graduated an instruction. These are typically used to determine if
incorrect application synchronization or simulator source code
modification has caused a deadlock. Defaults to 60.
- -c num
- Maximum number of cycles to simulate. Unused by default.
- -t num
- Number of cycles to simulate before dumping detailed
tracing information when RSIM is compiled with the debugging makefiles
described in Section 2.2.
Defaults to 0.
Vijay Sadananda Pai
Thu Aug 7 14:18:56 CDT 1997