Next: Approximate simulation models
Up: Command line options
Previous: Memory unit parameters
Most cache parameters are specified in the RSIM configuration file. The
command line parameters available are:
- -H num,num
- Number of MSHRs [10] supported at the L1
and L2 cache, respectively. Defaults to ``8,8''.
- -T
- Discriminate prefetching. If a hardware or software prefetch is stalled for
resource constraints at the L1 cache (e.g. all MSHRs full), it will be dropped
(to make place for later demand accesses that may also be stalled).
- -x
- Drop all software prefetches. Useful only for measuring instruction
overhead of prefetching.
Vijay Sadananda Pai
Thu Aug 7 14:18:56 CDT 1997